1746-NO8I Allen-Bradley is an analog output module for SLC 500. With eight (8) current output channels, this analog output module can provide an output range of 0 to +20 mA. Hardware in the SLC 500 fixed or modular type is utilized with this module.
how to setup and test the SLC500 1746-NO8I?
The SLC500 1746-NO8I must be setup and tested correctly, which entails a few important tasks as well as running the required tests to make sure the module functions as intended. Here are a few fundamental actions and ideas:
1.Location of installation:
When installing, it is important to take into account the effects of electrical noise and surrounding temperature. Installing the module close to the bottom of the chassis is advised because it produces a lot of heat, which will allow cold air to descend and aid in heat dissipation. To reduce electrical noise, keep the module away from high DC voltage, AC lines, and the system power source.
2.Installation process:
The module may be put in any slot of the local chassis, with the exception of slot 0, which is set aside for the CPU. The 1746-NO8I is compatible with any slot in expansion racks. It cannot be put in slot 0 of a remote I/O rack since that slot is only intended for SLC communication adapters, such as Ethernet, DH+, and RIO.
3.Test and verification:
To make sure the module is operating correctly, the required tests should be run after the installation is finished. This could entail confirming that the module complies with instructions from the control system and making sure the current output is accurate (1746-NO8I, for instance, should be able to generate a current signal of 0 to 21 mA).
4.Attention:
When testing, take note of any potential error codes or warnings, and follow the manufacturer’s instructions for troubleshooting. Modules should also undergo routine maintenance and inspections to guarantee their dependable and ongoing operation.
Previous : acs355-03e-23a1-4 ABB Frequency Inverter
Next :1746-no4i Allen-Bradley Analog Output Module
